Sccm 2016 logs not updating

I will be updating this post as the new versions are released.

To check the console and site version simply open the Configuration manager Console, click the blue tab in the top left corner and press About Configuration Manager.

Any thoughts on why the it is rebooting at this point and how could we resolve? Hi, What else has been done to the boot WIM (extra drivers etc.)? I can't think of anything else other than create a brand new boot WIM from scratch and check it. The SCCM Win PE is booting, however it is showing in 640x480 resolution and it is hard to maneuver the screens.

sccm 2016 logs not updating-6sccm 2016 logs not updating-5

We are able to PXE boot SCCM Win PE using WDS from our DP, however the resolution is low on the screen and all of the screens are big and hard to maneuver.

I have researched this issue on the internet and we tried the solution of deleting the E:\Remote Install\SMSBoot\to

If you’d like to know the CU version you need to check the registry on the site server.

How To Deploy Software Updates Using SCCM 2012 R2 In this post we will look at the steps on how to deploy software updates using SCCM 2012 R2.

This lets you configure a general maintenance window and a different maintenance window for software updates.

When a general maintenance window and software updates maintenance window are both configured, clients install software updates only during the software updates maintenance window.

The resolution and screens were much better, however when the SCCM Win PE booted and gets to "Preparing Network Connections", it reboots.

We were able to perform an F8 before reboot, and we noticed we are indeed getting a valid IP Address from DHCP.

Thank you for sending along all of these suggestions and information, however I had seen all of the referenced URLs and unfortunately they did not help our situation.

Tags: , ,